How can I edit my posted code in Predator CNC Editor?

I want to edit my posted code in Predator CNC editor but when I open the code it says it's read only. How can I edit it?

To be able to edit the code in predator, copy the file to a thumb drive or into the Jobs folder (found here if installed in Program Files C:\Program Files (x86)\Predator Software\Common Files\Jobs). This will allow the code to be edited. Opening from the desktop or a documents folder has been shown to give the read only flag. Note, this happens whether the checkbox in the file properties is checked or not.

Was this article helpful?
0 out of 0 found this helpful

Comments

1 comment
  • To be able to edit the code in predator, copy the file to a thumb drive or into the Jobs folder (found here if installed in Program Files C:\Program Files (x86)\Predator Software\Common Files\Jobs). This will allow the code to be edited. Opening from the desktop or a documents folder has been shown to give the read only flag. Note, this happens whether the checkbox in the file properties is checked or not.

    0

Please sign in to leave a comment.