How to Install a Post Processor for CAMWorks

Problem

This article goes over how to install your Post Processor. This article was written for CAMWorks 2014.

Solution

To install your post processor, follow the steps below, which are also attached as a PDF:

  1. Unzip/Extract the folder to access your post processor files
     

    Extract files
  2. Open your CAMWorks Post folder located here on a 64 bit system: C:\CAMWorksData\CAMWorks20XXx64\Posts 
  3. Drop all of the post files from your extracted folder into the designated post folder

    Put files in Post Folder
  4. Open your machine definition window within CAMWorks

    Open Post in CAMWorks
  5. Choose the Post Processor tab and select your machine's post processor from the list. Be sure to choose Select when finished.
Choose the Post Processor tab and select your machine's post processor from the list

For additional support, existing customers can submit a ticket or new customers can contact Hawk Ridge Systems.

Was this article helpful?
0 out of 0 found this helpful

Articles in this section

Comments

0 comments

Article is closed for comments.