Why is my rough feature not working when my tool and hole size are the same?

Problem

In CAMWorks, why is my rough feature not working when my tool and hole size are the same? For example, if you have a half-inch tool and you are trying to use it to cut a half-inch slot, the roughing feature does not work. 

Solution

This can be due to the fact that there is an allowance set inside the roughing tab. Try removing the allowance or manually change the tool size to say .499 or .498 and see if it works.

Adjust Allowance in Roughing tab of Operation Parameters

For additional support, existing customers can submit a ticket or new customers can contact Hawk Ridge Systems.

Was this article helpful?
0 out of 0 found this helpful

Articles in this section

Comments

0 comments

Article is closed for comments.