Essentials Assignments: Revolved Features & Shelling and Ribs

After completing the instructor-led portion of the Essentials course, work through the following:

Lesson Follow-up

1. Complete Exercise 27: Wheel. Apply Nylon material. Save your file in your designated folder. What is the mass of the part?
2. Complete Exercise 29: Ellipse.
3. Complete Exercise 30: Sweeps. Save each items as its own file (Slide Stop, Cotter Pin, Paper Clip, Mitered Sweep). Apply Galvanized Steel material to all 4 swept parts. What is the mass of each?
4. Complete Exercise 32: Pump Cover.
5. Complete Exercise 34: Compression Plate. Apply Aluminum Bronze material. Save your file. What is the mass of the part?
6. Complete Exercise 35: Blow Dryer. Start with a new file, creating the first sketch, shown on page 287. Apply ABS material. Save your file. What is the mass of the part?
7. Complete Exercise 38: Blade.

Tutorials

Do the following tutorials inside of SOLIDWORKS:

1. Revolves and Sweeps

SolidProfessor

Watch and follow along with all videos and all practice exercises in these sections. Check your work in the Practice Exercises. If needed, rework until you are able to get the right answer.

1. Continue Sketched Features Watch Video
2. Section 4 - Work with Revolves and Patterns Watch Video

Quiz Yourself

1. Take Quiz

Congratulations, you've completed your first week! Next week we'll take a look at Using SOLIDWORKS PDM and then continue with Essentials and preparing for the CSWA Exam.
Have a great weekend!