Follow

I want to add programming notes & comments into the output code. How can I do that?

Daniel Lyon

This can be done in a variety of ways. If the notes are specific to an operation then you can right click on the operation & use the Add Comment option. Anything added to the 'At start of Operation' portion will be output in the code. The 'Programming Notes' section is for reference and will not be output in the code.

Add_Comment__Operation.png

If the information is more generic (perhaps setup information) then a Post Operation can be used. The post processor needs to be setup to allow creation Post Operations. If you have created the post processor yourself or have the Source code (.SRC file) then you can use the attached instructions to create your own Post Operations that you can then add comments to.

How To - Post Operation Comments.pdf

Contact Us

For further technical support please contact Hawk Ridge Systems at 877.266.4469 for the U.S. or 866.587.6803 for Canada.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

  • Avatar
    Daniel Lyon

    This can be done in a variety of ways. If the notes are specific to an operation then you can right click on the operation & use the Add Comment option. Anything added to the 'At start of Operation' portion will be output in the code. The 'Programming Notes' section is for reference and will not be output in the code.

    Add_Comment__Operation.png

    If the information is more generic (perhaps setup information) then a Post Operation can be used. The post processor needs to be setup to allow creation Post Operations. If you have created the post processor yourself or have the Source code (.SRC file) then you can use the attached instructions to create your own Post Operations that you can then add comments to.

    https://hawkridgesystems.zendesk.com/attachments/token/xOlwgHz4KB9eiECSxy608dBar/?name=How+To+-+Post+Operation+Comments.pdf