Follow

How can I get rid of the dovetails or bow ties from multiaxis toolpath?

Daniel Lyon

These are caused when non tangent surfaces are machined and occur at the intersection of the non-tangent surfaces in the direction of the cut. Sometimes called dovetails or bow ties, this toolpath reversal can usually be fixed by checking the blend surfaces by tool radius on the Finish Tab.

image1.png

image2.png

Contact Us

For further technical support please contact Hawk Ridge Systems at 877.266.4469 for the U.S. or 866.587.6803 for Canada.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments