Follow

PDMWorks Not Enabled

Barry Shiong

If you have installed the PDMWorks Client and do not seem to have any access to the vault, make sure you have the Add-in turned on. To do this simply open up SolidWorks, hit Tools/Add-ins, and browse for PDMWorks and check it. The box on the left is for this session only and the box on the right will have PDM active on every start up.

If you do not see the Add-in Listed above most likely you didn't install it, see our documents on modifying an installation.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments