Follow

Simulation - General Troubleshooting

Barry Shiong
  1. Check for interferences. You can’t have them.
  2. Start slow…one part at a time, exclude what you don’t need.
  3. Follow from fixture to load or load to fixture. Everything must be connected with a connector, contact, or fixture. Fixture connects with respect to the environment, contact with respect to another and similar for a connector.
  4. When using shells and beams, make sure that the automatic bonding applies where you’re using it. It changes version to version. Shells are only connected by default at edges…etc.
Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments