Follow

I have a sketch with multiple regions and want to set it as an avoid area but it doesn't use some areas of it. Why?

Daniel Lyon

It picks certain areas but not others. Why?

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

  • Avatar
    Daniel Lyon

    The avoid area doesn't recognize splines in the sketch so it treats it as an open loop if there is one section with a spline in it. This was noticed when using convert entities to pull an edge into the sketch. The workaround was to use lines and arcs to create the profile instead. Using SolidWorks 2013 using CAMWorks 2013 SP1.

  • Avatar
    Cameron

    Good for customers?